Home / NISSAN Steering Knuckle / STEERING KNUCKLE FOR NISSAN NAVARA 22MM 40014-5X00C 40015-5X00C from China factory

STEERING KNUCKLE FOR NISSAN NAVARA 22MM 40014-5X00C 40015-5X00C from China factory

LZSK NO.: LZ-DZ551

Type: Steering Knuckle

Supply Ability: 100000 Pieces per Month

MOQ: 51 sets

REQUEST A QUOTE

Detail

Model:AUDI A4

Color:Black

Port:SHANGHAI OR NINGBO

Material:ALUMINUM

Product description

The steering knuckle is one of the important parts in the steering axle of the car, which can make the car run stably and sensitively transmit the driving direction. The function of the steering knuckle is to transmit and bear the front load of the car, support and drive the front wheel to rotate around the king pin to turn the car. In the driving state of the car, it is subjected to variable impact loads, therefore, it is required to have high strength. The steering knuckle is the hinge for turning the wheels, and is generally fork-shaped. The upper and lower forks have two coaxial holes for installing the kingpin, and the steering knuckle journal is used to install the wheel. The two lugs of the pin hole on the steering knuckle are connected with the fist-shaped parts at both ends of the front axle through the king pin, so that the front wheel can deflect a certain angle around the king pin to turn the car. In order to reduce wear, a bronze bushing is pressed into the steering knuckle pin hole, and the bushing is lubricated by the grease nipple installed on the steering knuckle. In order to make the steering flexible, a bearing is installed between the lower ear of the steering knuckle and the fist part of the front axle. An adjustment pad is also installed between the upper ear of the steering knuckle and the fist-shaped part to adjust the gap therebetween.